New Training Videos Released for R400 Series

  1. Home
  2. News
  3. New Training Videos Released for R400 Series

Three new training videos have been released in the new Training Videos page for the R400 Series, with two for K402 firmware and the other for K405 firmware.

In the first K402 Training Video, the K402 firmware is introduced including how to perform basic tasks using the firmware and its functionality.

In the second video, entitled K402 counting, describes how to create new products and how to set up piece counting in this firmware.

In the K405 Static Axle video, a brief demonstration is done on how to weigh a truck that stops on the load cell at each axle. The set up used is an R423 Indicator, a D841 Remote Display, the load cell, and a small tape printer.

For more videos released by Rinstrum, please see the Rinstrum Youtube Channel.

Menu

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close